Site visit or send-in evaluation
Share the feedback label, complete motor or machine order, drive model and alarm. Include both connector faces and note whether the issue followed a cable change, replacement or mechanical work.
What specialist testing can show
TI-5000JX bench. Mitchell documents J5 testing and distinguishes removable CSW from built-in CBW.
TI-3000JX motor run. Mitchell lists J5 run support. Confirm the fitted HK motor and firmware.
Mitsubishi Electric CSW26K J5 26-Bit Serial Encoder technical reference
Find your part number
Use the full fitted label. A motor order identifies the assembly and should be recorded separately from an encoder part number.
| ID or order code | Identification and scope |
|---|---|
| CSW26K | Removable 26-bit feedback identified by Mitchell. Match the encoder ID and motor. |
| CBW26K | Built-in type identified separately in the same article. |
| CSW26K INC | Mitchell selection for the distinct incremental-use ID associated with HK-MT. |
Production and end-of-life status
Confirm current orderability and any successor for the exact ID with the manufacturer or motor OEM. The dated documentation identifies the configuration.
Specifications
| Parameter | Verified scope |
|---|---|
| Position resolution | 26 bits, or 67,108,864 counts per revolution in the documented J5 motor system. |
| Retention | Batteryless absolute-position architecture in the applicable J5 configurations. |
| External connection | 10-pin DDK or hybrid connector, depending on HK motor build. |
Mounting and fit
Identify the HK motor order and whether the encoder is removable or integrated. Use the service drawing for rotor attachment and cable clearance. Confirm the replacement procedure before disturbing the feedback assembly.
Interface and measuring method
The J5 amplifier reads the feedback ID as well as position. Mitchell reports that the INC build has a different ID and the drive disregards its multiturn count. A bench reading alone cannot establish that the drive will use the same absolute mode.
Wiring and connector scope
Identify the motor-side connector before choosing the MR-J5 wiring figure. Mitchell illustrates a 10-pin DDK connection for listed HK-ST/HK-RT builds and a hybrid connector for the specified HK-KT/HK-MT/HK-RT builds.
Cables inside the motor and at the machine
TI-5732 applies to the documented DDK connection and TI-5772 to the documented hybrid. Confirm the OEM machine cable, motor order and amplifier separately. Identify any internal loom by the fitted assembly.
Fault checks
Before inspection. Follow the site’s isolation and lockout procedure. Secure any load against movement, allow the specified discharge time and have a qualified technician verify isolation. Check resistance on a disconnected harness at both ends. Use the documented shield and return connections.
| Observation | What to verify |
|---|---|
| Position is readable but the drive reports the wrong feedback mode | Compare the exact ABS or INC ID and the drive’s configured mode. |
| The expected test cable does not mate | Check DDK versus hybrid and confirm the exact HK motor option. |
| Axis reference changed after service | Verify the reference and commissioning steps in the applicable MR-J5 and machine manuals. |
Motor and drive applications
MELSERVO J5 motor options. Exact HK order open. Check the exact ID, drive and connector before applying an installation or test procedure.
Separate ABS and INC encoder IDs and match the fitted connector before selecting a bench profile.
Angle of alignment and commissioning
Record the motor and drive configuration, full encoder ID and original machine reference. Restore the reference using the approved machine procedure after installation. Treat feedback identity, angle verification and absolute position use as separate checks.
Drawings, pin maps and manuals
- Mitsubishi J5 guide. Overview and Rotary Motor Models. CSW26K, CBW26K and HK-MT INC.
- Mitsubishi Electric MR-J5 rotary servo motor manual. Motor selection, connection drawings, and the 26-bit feedback specification by series.