Site visit or send-in evaluation
Share the feedback label, complete motor or machine order, drive model and alarm. Include both connector faces and note whether the issue followed a cable change, replacement or mechanical work.
What specialist testing can show
TI-5000JX bench. The Mitchell B/P guide describes A/B/Z plus commutation testing with TI-5091 on the matched 17-pin MS connection.
TI-3000JX motor run. Exact motor run setup open
Reliance / Electrocraft B14H1060 Incremental Servo Feedback technical reference
Find your part number
Use the full fitted label. A motor order identifies the assembly and should be recorded separately from an encoder part number.
| ID or order code | Identification and scope |
|---|---|
| B14H1060 | Mitchell’s example of a B-series motor order. Record the fitted encoder label separately. |
| B-series feedback | Ono Sokki or equivalent incremental feedback with commutation in Mitchell’s family description. |
Production and end-of-life status
Confirm current orderability and any successor for the exact ID with the manufacturer or motor OEM. The dated documentation identifies the configuration.
Specifications
| Parameter | Verified scope |
|---|---|
| Position | Incremental channels in the named B/P motor application. Obtain the fitted encoder’s line count and levels. |
| Commutation | Separate signals are used for motor commutation. Verify the actual motor pole count. |
| Connector and supply | Confirm both from the motor and fitted encoder documentation. |
Mounting and fit
Photograph the encoder label, coupling and motor connector before disturbing the assembly. Obtain the original mounting and shaft drawing if the fitted device has a substitute manufacturer label.
Interface and measuring method
The drive uses incremental position and separate commutation information. Check position count, index and commutation behavior independently before interpreting a drive alarm as an encoder failure.
Wiring and connector scope
Use the B/P feedback connection figure and the exact fitted schematic to identify position and commutation groups. The Allen-Bradley HIPERFACE leads elsewhere in the Mitchell chapter apply to separate feedback builds.
Cables inside the motor and at the machine
Mitchell identifies TI-5091 for the B/P Ono Sokki ABZ/UVW branch with the 17-pin MS connector. Verify the plug and fitted encoder before using it on a B14H1060. The original internal loom number remains open.
Fault checks
Before inspection. Follow the site’s isolation and lockout procedure. Secure any load against movement, allow the specified discharge time and have a qualified technician verify isolation. Check resistance on a disconnected harness at both ends. Use the documented shield and return connections.
| Observation | What to verify |
|---|---|
| Position responds but torque is uneven | Compare the commutation signals and motor setup with the incoming reference. |
| Counts disappear when the cable moves | Inspect the strain relief and check the isolated loom before removing the encoder. |
| Feedback device has a different brand label | Compare the exact pinout, count, shaft and commutation before using it as a replacement. |
Motor and drive applications
B14H1060 Check the exact ID, drive and connector before applying an installation or test procedure.
Check position and commutation separately. Obtain the fitted encoder nameplate, pinout and actual motor poles.
Angle of alignment and commissioning
Capture the incoming commutation relationship, motor direction and exact pole count before removing a working feedback assembly. Apply the motor-specific service procedure and verify startup behavior on the approved setup.
Drawings, pin maps and manuals
- Reliance / Electrocraft guide. Overview and Identification. B/P feedback and B14H1060 example.
- Mitchell test cable index. TI-5091 entry in the Ono Sokki support section.