Site visit or send-in evaluation
Share the feedback label, complete motor or machine order, drive model and alarm. Include both connector faces and note whether the issue followed a cable change, replacement or mechanical work.
What specialist testing can show
TI-5000JX bench. Mitchell describes electronic alignment through the direct lead on CKS units.
TI-3000JX motor run. Exact motor run setup open
SICK CKS36-PFBPROGR 1035370 Programmable Commutation Encoder technical reference
Find your part number
Use the full fitted label. A motor order identifies the assembly and should be recorded separately from an encoder part number.
| ID or order code | Identification and scope |
|---|---|
| CKS36-PFBPROGR | Programmable incremental feedback with commutation. |
| 1035370 | Exact SICK item with axial 20-pin male connector and tapered shaft. |
Production and end-of-life status
Confirm current orderability and any successor for the exact ID with the manufacturer or motor OEM. The dated documentation identifies the configuration.
Specifications
| Parameter | Verified scope |
|---|---|
| Encoder supply | 4.5–5.5 V DC on SICK item 1035370. |
| Published setting | 2,048 lines per revolution in the exact datasheet. Verify the programmed value on the fitted device. |
| Commutation setting | Adjustable from 1 to 32 pole pairs in the SICK sheet. |
| Fit | Tapered shaft and spring mounting plate. Use the exact attachment drawing. |
Mounting and fit
The SICK attachment drawing shows the taper, securing thread and spring plate. The mounting plate and screws must be correctly seated before an alignment check. Match the OEM hardware and assembly procedure rather than using a generic CKS mounting assumption.
Interface and measuring method
Differential incremental channels report motion and the reference pulse. The programmed commutation pattern tracks the motor’s electrical cycle. Correct incremental counts can coexist with the wrong pole count or commutation reference.
Wiring and connector scope
Use the exact SICK 20-pin connector view and the CKS36 product information for signal assignments. Verify plug orientation and configured count before making an adapter. Connector and accessory options shown for other feedback products require their own drawings.
Cables inside the motor and at the machine
TI-5720 is the documented direct electronic alignment lead for supported CKS configurations. Confirm the exact pinout and mating fixture before connecting it. The installed motor loom is identified separately.
Fault checks
Before inspection. Follow the site’s isolation and lockout procedure. Secure any load against movement, allow the specified discharge time and have a qualified technician verify isolation. Check resistance on a disconnected harness at both ends. Use the documented shield and return connections.
| Observation | What to verify |
|---|---|
| Encoder counts correctly but torque is irregular | Review pole pairs and electrical reference before replacing the encoder. |
| Reference pulse missing with A/B intact | Check the programmed reference width and gating, then compare the Z pair at the receiver. |
| Fault appears after mechanical replacement | Check the taper and mounting plate seating before repeating electronic alignment. |
Motor and drive applications
Match the installed motor and its pole count. Check the exact ID, drive and connector before applying an installation or test procedure.
Distinguish correct counting from incorrect commutation. Check the fitted connector, programmed count and motor poles before service.
Angle of alignment and commissioning
Record the original electrical angle, actual motor pole count and phase reference. Mitchell’s electronic reset procedure uses a motor-specific zero electrical reference and is intended for a secured service bench. Validate count, direction and commutation before running the motor.
Drawings, pin maps and manuals
- CKS electronic alignment. General Description and Operation. CKS and TI-5720.
- SICK 1035370 datasheet. Exact item ratings, connector view and attachment drawings.
- SICK CKS36 product information. Series settings, electrical connections and installation context.