Hiperface SinCos® Encoders : Ready Stock : SCM70 Motor feedback systems

• old HIPERFACE® encoder series, which had 512 SIN/COS periods per rotation

• SICK NO longer produces Hiperface encoders, with 512 SIN/COS periods per rotation,

  Feedback systems for servomotors
  SinCos® SCS/SCM 60 and SCS/SCM 70
  (HIPERFACE® compatible)

• 512 sine/cosine periods per revolution
  • Absolute position with a resolution of 16384 steps per revolution | Number of steps per revolution
  • 4096 revolutions measurable (only Multiturn SCM)
  • Total number of steps : 67.108.864 = 16384 x 4096

• Position value programming
  • Encoder temperature interrogation
  • Electronic type label
  • 128 byte of EEPROM freely programmable by the user
  (for example configuration/commissioning data)
  • Individually configurable interface (baud rate and parity)
  • Only one mechanical interface for low-end and high-end applications

• Why you must buy this encoder:

  Because Sick offers no solution to end users/ buyers; There is no 1:1 replacement available. If the customer has the possibility to connect a HIPERFACE® encoder with 1024 SIN/COS periods, than they can use a SRS50 / SRM50 or SFS60 / SFM60 for replacement (depending which encoder series is mechanically closer).

  The customer has to decide about the mechanical design, which is most suitable to adapt to their application.

HIPERFACE® High Performance Interface
The universal interface for electric drives
Depending on their design and application, electric
drives need the following information from corresponding sensors in the control loop:
 Commutation information
 Rotational speed information
 Incremental position information
 Absolute position information over
several revolutions
All this information can be transferred via
HIPERFACE®.
Technical innovation to meet the highest requirements
was brought into the marketplace by STEGMANN with
their SinCos® product line.
The SinCoder® product line extends the range of motor
feedback systems for standard and low-cost applications. SinCos® and SinCoder® can be supplied with
compatible mechanical and electrical interfaces.
Electrical compatibility in respect of all physical parameters is ensured by the introduction of HIPERFACE®
as the mandatory interface.

1. Reliable data transmission • Only 8 lines
   • High information content • Parameter channel with bus capability
   • Electronic type label • Real-time process data channel
2. Benefit from the advantages of HIPERFACE®
   • only one interface to the speed controller for
   all applications
   • only one type of signal line between speed
   controller and signal transmitter
   • manual parameter setting on the speed contoller
   is dispensed with (intrinsic initialisation).